3.2.11. Connecting rod 1) Distorsion Check the connecting rod for distortion. As shown in the figure below, install the connecting rod to the connecting rod tester, and check for distortion using a feeler gauge. If the connecting rod is found distorted, never re-use it but replace with a new one. 3) Wear Assemble the connecting rod to the crankshaft and measure connecting rod big end side clearance using a feel- er gauge. Assemble the connecting rod to the piston and measure connecting rod small end side clearance. If the measured values are beyond the limit, replace the connecting rod.
- 57 - Holes alignment (parallelism) Measure the alignment of the connecting rod piston pin bushing holes with con- necting rod big end holes. At this time also, use both connecting rod tester and feeler gauge. Standard Limit 0.05 mm 0.1 mm or less EA0M4034 EA0M4034 Standard Limit 0.05 mm 0.1 mm or less Limit 0.5 mm