daewoo DE12T / P126TI — Daewoo DE12T / P126TI User Manual

Apply oil to the entire part of the bearing cap bolts, then tighten in tightening sequence to specified torque. After semi-tightening both bolts evenly, tighten them diagonally to about 15kg.m for the first stage and 25 kg.m for the EQM3059I second stage respectively, then tighten them completely to the specified torque using a torque wrench. Tighten the bearing cap in the sequence of 4-3-5-2-6-1-7. Check to see that the assembled crank- shaft turns smoothly. 3.3.6. Flywheel housing Temporarily install the guide bar on the cylinder block. Apply gasket to the cylinder block.

Using the dowel pin and guide bar, install the flywheel housing and tighten the fixing bolts in a diagonal sequence to specified torque. EQM3060I 3.3.7. Rear oil seal Apply lubricating oil to the outside of theoil seal and flywheel housing inside diameter and fit them over the crank shaft, then assemble the oil seal using an oil seal fitting jig. - 61 - Torque 30 kg•m Torque 12 kg•m