4.1.3. Thermostat General descriptions and main data The thermostat maintains a constant tem- To radiator perature of coolant (90 ~ 95 C) and improves thermal efficiency of the engine by preventing heat loss. Namely, when the temperature of coolant is low, the thermostat valve is closed to Bypass valve From cooling water pump make the coolant bypass to directly enter To bypass tube the water pump; when the coolant temper- EAMC002I ature rises to open wide the thermostat valve, the bypass circuit is closed and the water passage to the radiator is opened so that the coolant is forced to flow into the radiator. Inspecting (1) Check the wax pallet and spring for damage. Bar Temp.
gauge (2) Put the thermostat in a container of water, then heat the water slowly and check temperature with a thermometer. If the valve lift is 0.1 mm (starting to Wooden plate open) at temperature of 83 C and 8 mm or more (opening wide) at temperature of 95 C, the thermostat is normal. EFM2055I Replacing thermostat and precautions for handling (1) Precautions for handling The wax pallet type thermostat does not react as quickly as bellows type one to a vari- ation of temperature of coolant. Such relatively slow reaction is mainly due to the large heat capacity of the wax pellet type thermostat.
Therefore, to avoid a sharp rise of coolant temperature, it is essential to idle the engine sufficiently before running it. In cold weather, do not run the engine at overload or overspeed it immediately after start- ing off. (2) When draining out or replenishing coolant, do it slowly so that air is bled sufficiently from the entire cooling system. (3) Replacing thermostat If the thermostat is detected defective, retrace with a new one. - 83 - Item Specifications Type Wax-pallet type Open at 83 ˚C Open wide at 95 ˚C Valve lift 8 mm or more