f. Install the dial gauge on the holder assem- bly so that the pin is brought into contact with the upper end of the push rod, then fix the pin with the nut. Note 1 : Fix the dial gauge so that a stroke of 2 mm or so can be mea- sured. Note 2 : Overtightening the nut may cause a sticking of the dial gauge seat. g. Assemble the nozzle and nozzle holder assembly to the nozzle tester and zero the dial gauge. h. Operate the nozzle tester, bleed the retain- ing nut, and check for fuel leakage. I. Operate the nozzle tester and increase the tester pressure up to 350 ~ 450kgf•cm 2 in order that the needle valve can be fully lift- ed. Then, record the full lift value “L”. Note :
This testing is to be made in order to check the nozzle seat portion for unusual wear or whether the nozzle assembly is a standard item. - 112 - L 0 EQM4048I EQM4048I