daewoo DE12T / P126TI — Daewoo DE12T / P126TI User Manual

- 133 - Remarks In horizontal and vertical directions 96 g6 83 g6 Measure in the position of crown No.4 bearing(holding Nos. 1 & 7) Measure at 400 rpm No foreign matters on bearing cap installing surface Measure by tightening metal cap and then loosening one stud bolt Replace with new one, use shim After completing installation of bearing, loosen one stud bolt and measure 60 Correction Correct with a grinder Replace crank shaft Replace crank shaft Replace bearing Replace thrust bearing Adjust by a press if bent Check dynamic balance Apply oil to bolt Replace oil seal if oil leaking Replace bearing Replace conn.

rod Apply oil to bolt Replace thrust plate Replace thrust collar Limit for use 0.1 94.966 81.966 0.025 0.03 0.03 0.25 0.5 0.1 or less 60 or less - - - 0.20 0.5 0.12 - - - 59.52 0.20 0.3 0.15 0.3 Standard value for assembly 0.05 95.966~ 95.988 82.966~ 82.988 0.008 0.01 0.01 0.072~0.142 0.15~0.325 0.05 60 30 0.15~0.25 - 0.049~0.119 0.22~0.319 0.050~0.080 0.086~0.116 18g ± 28 59.860~ 59.880 0.050~0.128 0.13~0.27 0.025~0.091 0.043~0.167 Check Axial run-out of journal and pin Outside diameter of journal Outside diameter of pin Out of round of journal & pin Permissible radial run-out of journal & pin Permissible taper of journal & pin Clearance between crank shaft & bearing End play of crank shaft Run-out of crank shaft Balance of crank shaft Tightening torque of journal bearing cap bolt(kg.m) Journal bearing crush Oil seal for wear Clearance between conn.

bearing & crank pin End play of con. rod crush Clearance between small end bush & piston pin Conn. rod bearing crush height Permissible weight difference of each conn. rodrod Tightening torque of con-rod bearing cap bolt (kg•m) Outside diameter of cam shaft Clearance between cam shaft and bush Axial play of camshaft Clearance between idle gear shaft and inserting hole End play of idle gear shaft Part Crank shaft Conn. rod Cam shaft Timing gear Group Major moving parts