daewoo DE12T / P126TI — Daewoo DE12T / P126TI User Manual

Maintenance specification table - 132 - Remarks Measure unworn portion beneath the rim of upper side Per distortion length for 200mm In case of new valve and seat Water temp : 70˚C Measure unworn portion beneath the rim of upper side Standard gauge inside diameter : 123 Limit for use if for standard clearance Correction Replace liner Correct with a surface grinder Replace cyl.

head Replace if leaky Replace piston if groove width is beyond specified value Replace ring or piston Install ring by 120° Limit for use 123.223 - - - 0.55 0.55 113.9 - - - - - - - 96g 1.5 1.5 1.5 - 0.15 0.15 - Standard value for assembly 123~ 123.023 0.03~0.08 0.05 4 0~0.3 0~0.3 114.95~115 4 122.854~ 122.886 0.114~0.169 3.5 3.060~3.080 4.040~4.060 0~0.12 15g ± 0.30~0.45 0.35~0.50 0.30~0.50 - 0.07~0.102 0.05~0.085 - Check Inside diameter of Cylinder.

liner for wear Projected portion of liner The upper surface of cylinder block for distortion Hydraulic test for 1 minute (kg/cm2) Intake Exhaust Height Hydraulic test for 1 minute (kg/cm2) Piston diameter (18mm from the lower side) Clearance between piston and liner Tor ring 2nd ring Oil ring Piston projection from cylinder block upper surface Permissible weight difference of each piston Top ring 2nd ring Oil ring Top ring 2nd ring Oil ring Direction of ring gap Valve seat depression Width of piston ring grooves Piston ring gap Piston ring groove clearance Part Cylinder block & liner Cylinder head & valve Piston Piston ring Group Engine body Major moving parts