daewoo DE12T / P126TI — Daewoo DE12T / P126TI User Manual

6. Checking and setting 6.1. Adjustment of valve clearance 6.1.1. General information The valve clearances are to be adjusted at the times of the following situations. After initial 50 hour’s operation. When the engine is overhauled and the cylinder heads are disassembled. When severe noise comes from valve train. When the engine is not normally operated, even though there is no trouble in the fuel system. The valve clearance of the cold engine are as follows. - Intake valves : 0.3mm - Exhaust valves : 0.3mm 6.1.2.

Adjusting order of the valve clearance 1) After letting the #1 cylinder’s piston come at the compression top dead center by turning 2) Loosen the lock nuts of rocker arm adjusting screws and push the feeler gauge of the crankshaft, adjust the valve clearances. specified value between a rocker arm and a valve stem and adjust the clearance with adjusting screw respectively and then tighten with the lock nut. 3) As for the valve clearance, adjust it when in cold, as follow. - By cranking the engine, let #6 cylinder’s valves overlap. - In time, adjust the valve clearance corresponding to “ ”of lower lists. - Adjust the valve clearance corresponding to “ ” of lower lists.

- After reinsuring the valve clearances, retighten if necessary. 4) No. 1 Cylinder is located at the side where flywheel was installed. - 42 - Model Intake Valve Exhaust Valve DE12T P126TI 0.3 mm 0.3 mm