daewoo DE12T / P126TI — Daewoo DE12T / P126TI User Manual

soak in a vessel with solvent and to clean it then with a stiff brush. In doing so, take care to see that only the compressor wheel is immersed and that the turbocharger is supported on the bearing casing and not on the wheel. 5.7.2. Special hints It is recommended that the radial and axial clearances of the rotor be checked after Turbine wheel chamber every 3,000 hours operation. Magnetic vise This precaution will enable any wear of the Measuring of axial clearance bearings to be detected in good time before serious damage is caused to the rotor and bearings. Move the turbine shaft to axial direction Dial gauge Measuring rotor axial clearance Wear limit :

0.20mm EA4M2017 Measuring radial clearance Dial gauge Magnetic vise Oil Outlet Radial play Limit of wear : 0.57mm Move the turbine shaft in both directions simultaneously Oil inlet EA4M2018 - 41 - Axial clearance 0.2 mm Radial clearance 0.65 mm