daewoo DE12T / P126TI — Daewoo DE12T / P126TI User Manual

EFM1006I Normal Abnormal Abnormal Install a nozzle to a nozzle tester. Check injection pressure, and adjust the nozzle using the adjusting shim if the pressure does not meet the specified limit. Check nozzle spray patterns and replace if damaged. Caution : The injection lines are designed for high operating pressures and should thus be handled with particular care. When mounting the pipes to the engine take care of good fitness. Do not bend pipes to permanent deformation (not for replacing the nozzles either). Do not mount any heavily bent pipes. Avoid bending the pipes at the ends by more than 2 to 3 degrees.

In case of faults in the injection system which might have resulted in excessive operating pressures, not only the failed part but also the injection line has to be replaced. 5.7. Turbocharger 5.7.1. Maintenance (by authorized specialist personnel) The turbochargers do not call for any specific maintenance. The only points to be observed are the oil pipes which should be checked at every oil change for leakage and restrictions. The air cleaners should be carefully serviced. Furthermore, a regular check should be kept on charge air exhaust gas pipes. Any leakages should be attended to at once because they are liable to cause overheating of the engine.

When operating in highly dust or oil-laden atmospheres, cleaning of the air impeller may be necessary from time to time. To this end, remove compressor casing (Caution : Do not skew it! ) and clean in a non-acid solvent, if necessary using a plastic scraper. If the air compressor should be badly fouled, it is recommended that the wheel be allowed to - 40 - DE12T P126TI Injection Nozzle pressure 220kg/cm2 1st : 160kg/cm2 2nd : 220kg/cm2