Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING after the engine is stopped, and may cause burns. Wait for the diagram on the right. 5. If the level is below the correct line, add oil through filler port (F) at the top of the hydraulic tank. 3 - 81 temperature to go dow When removing the oil filler cap, turn it slowly to release t 1. Set the work equip ment in the posture shown in the diagram on the right, then che ck the oil level and add oil if nec essary. own in the gine at low 2.

If the work equip diagram on the rig speed, retract the lower the boom, se and stop the engin ment is not in the condition sh ht, start the engine, run the en arm and bucket cylinder rods fully, then t the bucket teeth in contact with the ground, e. s after stopping the engine, move each 3. Within 15 second control lever (for w in all directions to r ork equipment and travel) to th e full stroke elease the internal pressure. 4. Check oil level gau ge (G) at the rear of the hydrauli c tank. The oil level should b temperature. If the e within the specified range oil level is low, add oil. for that oil The proper way to che ck the hydraulic oil level is as fo llows.

5°C to 30° When the hydraulic oil is at normal temperature (1 C), the oil level shou ld be within the blue range of gau ge label (a) in the diagram on th e right. When the hydraulic oil is at high temperature (50°C t o 80°C), the oil level should be w ithin the red range of gauge lab el (b) in the