. OPERATION MACHINE OPERATIONS AND CONTROLS 1. This machine is equipped with an automatic engine warm-up system, so if the engine water temperature is below 30 ° speed. speed. 1] Turn fuel control dial (2) to the full speed (MAX) position and hold it for 3 seconds. 3 - 102 e engine is started, the en gine warm-up o peration starts autom atically. When the e ngine operation starts, the engine speed is maintained at a speed highe r than the normal low i dling the engine water te mperature goes above 30 °C or if the warm-up operation has be en continued for more than minutes, the auto matic warm-up operation i s cancelle d and the e ngine speed dro ps to the normal low i dling .
Check that engine green. If it displays white, additional warm up green. water temperature monitor (1) displays use the procedure in Step 3 to carry out of the engine until the monitor displays . Turn fuel control dia l (2) to a point midway bet ween low i dling (MIN) and full spee speed, and run und monitor (1) displays d (MAX), run the engine at a mid-range er no load until engine water temperature green. er temperature If t he engine water temp erature monitor displays g reen, the engin e warm-up operation i s completed. After checking that the e ngine water temperature m onitor displays g reen , carry out the wa rming-up operation f or the hydraulic equipment.
NOTIC Canceling automatic warm If it becomes necessary in an emergency to cancel the au tomatic warm-up operation or to lower the engine speed to low id le, do as f