. MAINTENANCE MAINTENANCE PROCEDURE Mixing rate of water and antifreeze -35 -40 -31 -40 76.8 82.5 65.5 59.8 20.29 21.80 17.31 15.80 54 58 WARNING resistor to the CLOSED position. 4 - 21 To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant d 68%. between 30% an When deciding th e ratio of antifreez e to water, check t he lowest temperature in the past, and decide from the mixing table given below . er to estimate and temperature about 10°C (18°F) lower when deciding the mixing ratio. depends on the ambient temperature, but it should always be a minimum of 30% by volume amount of coolant x 100).
It is actually bett er to estimate and temperature abou t 10°C (18°F) lower when deciding the The mixing ratio depends on the (antifreeze/total amount of coolant Even in areas wh ere it is not neces sary to prevent fre ezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent c orrosion of the co oling system. The freezing tem perature of undilut ed antifreeze is -1 5°C (5°F). Do not store undiluted antifr eeze at a temperature of below -15°C ( 5°F). Min.
atmosph temperature eric °C A °F A bove-10 -15 -20 -25 -30 bove14 5 -4 -13 -22 Amount of antifr liter eeze US gal 42.7 51.2 58.2 65.5 71.2 11.28 13.53 15.38 17.31 18.81 liter 99.6 91.1 84.0 76.8 71.2 ter US gal 26.31 24.07 22.19 20.29 18.81 Volume ratio (%) 30 36 41 46 50 Antifreeze is fla mmable, so keep it a way from flame. Antifreeze is tox ic. When open the d rain valve, be carefu l not to get water containing antifreeze on y ou. If it gets in your eyes, flush your eyes with large amount o f fresh water and se e a doctor at once.
When changing the coolant or draini ng the coolant from the radiator before carrying out repairs, ask a specialist company to handle any coo lant containing anti freeze, or contact y our Komatsu distributor. Antifreeze is toxic, so never pour it into ce. drainage water ditches or drain it on to the ground surfa Use antifreeze an d appropriatewat er for diluting. (for details, see "COOLANT AND WATER F OR DILUTION (PAGE 4-5)") use of an antifreeze density gauge to control the mixing proportions. ner whose capacity is larger than the specified coolant volume to catch drained coolant. o supply antifreeze coolant and water.
We recommend use of an antifreez e density gauge t Prepare a contai ner whose capacit y is larger than th e specified coolant volume to catch dra Prepare a hose t o supply antifreez e coolant and wat . Stop the ma chine on level gro und, then stop the . Open the en gine room door an d turn valve (1) of