Komatsu — CLEAN INSIDE OF COOLING SYSTEM

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE (4) on the radiator side and drain 4 - 22 3. Remove cover (2). Check that the cooling w ater temperature has gone down 4. own enough to make it possible to touch the radiator cap surfac e by hand, then turn radiator c ap (3) slowly until it contacts the sure. stopper to release the pres 5. Following this, push radiat or cap (3), turn it until it contact s the stopper, then remove it. 6. valve cover (5) on the eng 7. Set containers to catch th e drained coolant under drain v alve (6) on the radiator side an d drain valve (7) on the engine Open drain valves (6) and 8.

After draining the antifreez e solution, close drain valve (6) , (7), then fill with clean water. A fter the radiator is filled with w ater, start and run the engine a t low idling speed. After the water 90°C (194°F), run the engine for n drain valves (6), (7) to drain the ean the radiator with detergent. ollow the instruction of detergent. ater temperature rises above about 10 minutes. Stop the engine and ope water. 9. 10. After draining the water, cl ean the radiator with detergent For the cleaning method, f ollow the instruction of deterge 11. Close drain valves (6), (7). 12. Install the covers (4) and ( 5). istor, then turn valve (1) to the OPEN position.

(Only on machines equipped with of replacing the corrosion resistor, see "REPLACE CORROSION RESISTOR )". tifreeze until it overflows from the water filler. 13. Replace the corrosion res corrosion resistor) For details of the method CARTRIDGE (PAGE 4-69 14. Add coolant mixed with an tifreeze until it overflows from t Decide the proportions of a ntifreeze and water according t o the table for the mixing rate o f water and antifreeze 15. Run the engine at low idlin g for 5 minutes to remove the a ir fro m the water, then run at hi gh idling for 5 minutes. ( Leave radiator cap (3) re moved when doing this. )