. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 2) If no oil oozes out, remove the drain hose from the pump case, and add hydraulic oil through drain port (2) to fill the pump case. Oil will come out when the drain hose is removed, so secure the hose mouthpiece at a position higher than the level of the oil in the hydraulic tank. 3) After completing the air bleed operation, tighten air bleeder (1) and install the drain hose. oil, 2. Starting engine After that, do as follows. 3.
Bleeding air from cylinders NOTICE NOTICE 4 - 38 NOTICE If the drain hose is instal led first, oil will spurt out from air blee If the pump is operated without filling the pump case with hy abnormal heat will be gen erated and this may cause premature the pump. tic warming-upoperation, start the engine, and run it at low idling for 1 0 minutes after starting. llows. ylinders e at low idle, and extend and retra ct each cylinder 4 to 5 times, taking care that a cylinder is he end of its stroke. (Stop the cyli nder approx. 100 mm (3.9 in) short of its stroke end) ove the air. each cylinder 3 to 4 times to the e nd of its stroke.
e each cylinder 4 to 5 times to the end of its stroke to completely rem If the engine is run at high speed immediately after startup or a c ylinder is pushed up to its stroke end, ai r taken inside the cylinder may cause damage to th 4. Bleeding air from swing motor (bleed the air only wh 1) Run the engine at low idling, remove hose (1) at p check that oil oozes out from port S hose (1). NOTICE Do not operate the swing under any circumstances. 2) If oil does not ooze out, stop the engine, remo hose (1), and fill the inside of the motor case with oil.
wing motor (bleed the air only wh en the oil inside the swing motor c ase has been drained) at low idling, remove hose (1) at p ort S, and ve port S hydraulic ly bleeding the air, tighten port S h ose (1). at low idle, and slowly swing the u pper structure at least 2 times unifor mly to the left and right. If the air is not bled from the swing motor, the motor bearings m