Komatsu — BLEEDING AIR FROM HYDRAULIC SYSTEM

. MAINTENANCE MAINTENANCE PROCEDURE If (2) one turn. 4 - 39 5. Ble eding air from attac n attachment has b een installed, run the engi ne at low idling and operate the attac hment pedal repeatedly prox. 10 times) until the air has been bled fro m the attachme NOTICE If the method of bleeding t he air from the attachment it self is specified b y the manufacturer, ble ed the air according to the spec ified procedure. After completing the air ble eding operation, stop the eng ine, and leave the machine for 5 minutes before starting operations. This will remove the air bub bles in the oil inside the hyd raulic cylinders.

Chec k that there is no leak age of oil and wipe off any oil that has been eding air from trave he piping has been ed the air after rea gine at low idling an Start the engine an Remove travel mot or cover (1), then loosen a ir bleed plug NOTICE Do not l oosen plug (2) more th Carry out fine ope FORWARD and R ration of the travel leve EVERSE 4 - 5 times. r and set to When no more clo udy white oil comes out from air bleed bleed plug (2). tor cover. plug (2), tighten air Install the travel mo