Komatsu — REPLACE FUEL PRE-FILTER CARTRIDGE

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE on remove it. dirt from entering the inside of the filter cartridge. 4 - 52 2. Set the container to ca tch the fuel under the filter ca rtridge (1). Remove transparent c broken or damaged, re Using a filter wrench, t up (2) from the filter and insp place it with a new part. urn filter cartridge (1) counte 5. Clean transparent cup (2) and remove seal (3). Co at the new seal with clean fuel or oil. (2) to the new filter cartridge. up: 10 Nm (1.0 kgm, 7.2 lbft) 6. Install transparent cup (2) to the new filter cartridge Tightening torque for c up:

10 Nm (1.0 kgm, 7.2 lbft) NOTICE t is not necessary to fill the fi Cap When replacing the filt er cartridge, check that drain plug (4) at the bottom of transpar ent cup (2) is securely tighte ned. (Tightening torque: 0.2 -0.4 Nm (0.02 - 0.046 kgm, 0. 1 - 0.3 lbft) 7. Clean the filter cartridg that there is no dirt or e mount on the filter holder damage. In particular, if ther and check e is dirt or damage to seal surfac will leak, and it will lea es (B) or (C), air will be sucked in or fuel d to the entry of dirt. ce of the filter cartridge with oil. cap (A), check that there is no dirt or 8. Coat the packing surfa ce of the filter cartridge with 9.

Remove filter cartridge cap (A), check that there is damage to the filter ho lder and filter cartridge, then install the er holder. install the filter cartridge to the filt 10. When installing, tighte n until the packing surface co ntacts the seal surface of the filte r holder, then tighten it 3/4 o f a turn. If the filter cartridge is tightened too far, the pack l lead to leakage of fuel. I ing will be damaged and this wil f the filter cartridge is too loose, fuel will also leak from the packing, so ect amount. always tighten the corr