Komatsu — CHECK, REPLACE ALTERNATOR, AIR CONDITIONER COMPRESSOR DRIVE BELTS

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN STRAINER OF PTO LUBRICATING OIL FILTER WARNING 1. Open the cover at the rear left of the machine, then remove filter case (1). 2. Take out the strainer, remove any dirt stuck to the strainer, then wash it in flushing oil. If the strainer is damaged, replace it with a new part. 3. Install the strainer and filter case (1). CHECK, REPLACE ALTERNATOR, AIR CONDITIONER COMPRESSOR DRIVE BELTS 4 - 59 The parts a nd oil are at high tempe rature after the eng ine is stopped, and may cause serious burns . Wait for the temperature to go down before cleaning the en gine breather.

When using compressed air, there is a hazard that dir t may be blown up and cause serious injury. Always use safety glasses, dust m ask, or other protec tive equipmen Checking Check the be lt and when the foll owing conditions e xist, replace the When crac king and peeling of the belt occurs. When belt is worn and there a re vertical cracks. Replacement 1. Loosen lo and loos 2. Replace 3. Loosen p can be s 1. Loosen lo cknut (2) of push bo lt (1), then screw i n push bolt fully ening tension pulley. 2. Replace 3. Loosen p een, then tighten loc knut (2).