Komatsu — REPLACE HYDRAULIC OIL FILTER ELEMENT

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING the engine is stopped, and may cause burns. Wait for the 4 - 63 EVERY 1000 HOURS MAINTE NANCE Maintenance for every 10, 100, 250, and 500 hours of servi ce should be performed at the T emperature to go down before starting W hen remov ing the oil filler cap, turn it slowly to release the int 1. Remove t he cap from oil filler (F) on top of the hydrauli c tank, and relea se the internal pressure . er (1). 2. Loosen 4 bolts, then remove cov When doi ng this, the cover may fly out under the force of spring (2), hold t he cover down when re 3.

After rem element ( If there (5), con element ( If there are metal particles or fo reign material inside s trainer tact your Komatsu distr ibutor. ng oil. 4. Clean the removed parts in flushi 5. Install the new element in the plac e where old element ( 4) was installed. REMARK When doing th is, check that the seat s urfaces (both ends) of spring (2) are horizo ntal. Check that th e seat surface of the spr ing is not raised as sh own in diagram (A) o n the right. 6. Set valve (3), strainer (5) and spr ing (2) on top of the el ement. 7. Set cover (1) in position, push it d own by hand, and ins tall the cover with the mountin 8. Install the cap of oil filler port (F). 9.

To bleed t he air, start the engine a ccording to "STARTIN G ENGINE (PAGE 3-98)" and r un the engine at low idle for 10 min utes. ngine. 10. Stop the e