. MAINTENANCE MAINTENANCE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE (If equipped) WARNING The oil is at high temperature after the engine has been operated, so never replace the cartridge immediately after finishing operations. Prepare a filter wrench for fuel filter element. 4 - 69 Wait for the oil to cool do wn before replacing car Container to catch 1. Turn valve (1) to t he CLOSE position. er the cartridge. 2). 2. Set a container to catch the coolant und er the c 3. Using a filter wren ch, remove cartridge ( 4. Clean the filter hol der, coat the packing surface and threa d of the new cartridge with oil, then install it t o the fil ter holder. 5.
When installing, ti ghten until the packin g surfac e contacts the seal surface of the filter holder, then tigh ten it u p 2/3 of a t urn. If the filter cartrid ge is tightened too fa r, the p acking will damaged and this will lead to leakage o f coolan If the filter cartridg e is too loose, coolant will als o leak from the packing, so alway s tighten to the correc t amou 6. Turn valve (1) to t he OPEN position. 7. After replacing the cartridge, start the en gine and check for any l coolant leakage f rom the filter seal su rface. I f there any eakage, check if t he cartridge is tighten ed properly.