. MAINTENANCE MAINTENANCE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT WARNING 4 - 79 The hydraulic system is always under int ernal p ressure, so when inspecting or replacing the pipi ng or hoses, always release the pressure in the circuit befor e starting. If the pressure i s not released , high pressure oil may s purt out and cause serious personal injury The parts and oil are at high temperature after t he engine is stopped, and may cause serious burn s. Wait for the temperature to go down be fore starting the o peration. When the oil fi ller cap is removed, oil ma y spur t out, so tur n the cap slowly to release the pressur e before removing the cap. 1.
Stop the m achine on firm horizont al ground, lowe r the work equipment t then stop th o the ground as shown i n the diagram o n the right, e engine. Set the lock l ever at the FREE positi on (F 2. Turn the sta rting switch to the ON p osition. 3. Operate ea ch work equipmen t cont rol lever to the f ull stroke within 5 - 6 seconds afte 4. Remove the cap of the hydraulic ta nk. seconds, then stop the engine again. an 1000 rpm. evers to the HOLD position. osition. 5. Start the en gine, run for approx. 10 seconds, then stop the Do not ru Set the w n the engine at more th an 1000 rpm. ork equipment control l evers to the HO LD position. 6. Turn the sta rting switch to the ON p osition. 7.
Operate ea ch work equipmen t cont rol lever to the f ull stroke within 5 - 6 seconds afte Repeat S teps 5 - 7 three times.