. MAINTENANCE MAINTENANCE PROCEDURE leakage. If any distributor for disassembly and repair or replacement. WARNING the the a to The accumulator is installed to the position shown in the diagram on the right. 4 - 80 EVERY 4000 HOU Maintenance for every 10, 100, 250, 500, 1000, and 2000 hour s of service should be perfor med at the same time. CHECK WATER PU Check that there is abnormality is found , contact your Komats CHECK STARTING MOTOR Wear on the brush and the bearings short of grease a re suspec ted, so ask the Komatsu dis tributor in your territory for the repairs.
CHECK AIR COMPR ESSOR, ADJUST As special tool is requi red for checking and adjusting the parts, request Komatsu distributo REPLACE ACCUMULATOR (FOR CONTROL CIRCUIT) Replace the accumula tor every 2 years or every 400 0 hours, w The accumulator is charg ed with high-pressure nitrogen ga s, so mista ken operation may cause an exp losion, which will lead to serious injury or damage . When handling the accumulator, always do a s follows. The pressure in the hy draulic circuit cannot be complete ly removed . When removing the hydraulic equipment, do not stand in the direction that th the operation. e oil spurts out when carrying out t he operatio n.
In addition, loosen the bolts slowly when carrying out e accumulator. me or dispose of it in fire. t or weld it. subject it to any impact. Do not disassemble th Do not bring it near fla Do not make holes in i Do not hit it, roll it, or When disposing of th e accumulator, the gas must be re leased. Ple ase contact your Komatsu dist ributor to have this work carried out. If operations are c ontinued after the performance of t ped, it will be impossible to release t accumulator has drop e to remaining pressure in the hydraulic circuit if there should be e. Please ask your Komatsu distributor or. should be failure on the machin replace the accumulat