Komatsu — MAINTENANCE

. ATTACHMENTS AND OPTIONS AUTO-GREASING SYSTEM ATTACHMENTS AND OPTIONS AUTO-GREASING SYSTEM 5. Tighten plug (2) of the injector to prevent the grease from leaking. 14.5 - 21.7 lbft) Carry out Steps 1 to 5 for every injector. on the box on the side of the normal, indicator pin (5) moves up and down in a piston movement. 6 - 20 Tightening torque of plug ( 2): 19.6 - 24.9 Nm (2.0 - 3.0 kgm 6. Remove cap (4) from service grease nipple (3) of the injecto 7. Operate the grease gun man ually to fully charge all the branc lines with grease.

For details of the location of th e injectors, see "Greasing Point for Auto-greasing System (P REMARK f th e auto-greasing system does not work properly and grease i not supplied, use the grease gun and carry out greasing manuall rom service grease nipple (3) in stalled to each injector. 8. Tighten cap (4) of service gre ase nipple (3) of the injector. gm, 2.9 to 4.3lbft) Tightening torque of cap ( There is no check device t there is danger that high-p forget to tighten the cap. Tightening torque of cap ( 4): 3.92 to 5.88 Nm (0.4 to 0.6 k gm, 2.9 to 4.3lbft) There is no check device t o prevent reverse flow in service grease nipple (3).

If you forget to tig hten ca p (4), ressure grease may spurt out w hen the grease pu mp is actuated. B e sure n ot to 9. After completing the operatio n in the Steps 1 to 8, set the a uto-greasing switc console on the right side of t he operator's seat to the AUTO position. 10. Turn the machine starting sw itch ON and check that indicato pin (5) of each injector is wo rking properly. If the condition i