. LOADING SHOVEL MAINTENANCE MAINTENANCE CHECK BEFORE STARTING Check Oil Level in Hydraulic Tank, Add Oil WARNING after the engine is stopped, and may cause burns. Wait for the 7 - 22 temperat ure to go down be fore starting the When re moving the oil fille r cap, turn it slowly to release t 1. Set th e work equipmen t in the posture shown in the diagram on the rig ht, then check th e oil level and add oil if nec essary. own in the gine at low 2.
If the work equipmen m on the right, t is not in the condition sh e, run the en diagra start the engin e, speed , retract the ar m and bucket cylinder rods fully, then lower t he boom, set the bucket teeth in contact with the ground, and st op the engine. fter stopping the engine, move each 3. Within 15 seconds a he contro l lever (for work equipment and travel) to th e full stroke in all d irections to rele ase the internal pressure. 4. Check oil level gauge ( G) at the rear o f the hydrauli c tank. The oil lev el should be w ithin the specified range evel is low, add oil. for that oil temperature. If the oil l evel is low, ad