. OPERATION DETAILED CONTROLS AND GAUGES OPERATION DETAILED CONTROLS AND GAUGES (Press Back switch (8) to return to the previous screen.) speed returns to normal. 11. When the fan returns to rotating in the normal direction, the display switches automatically to the initial screen. 3 - 29 9. When changing the fa n rotation direction from rev erse direction to the normal switch (11). direction, press input confirmation 10.
When the fan rotation is b eing changed, the screen chang es to engine is automatically set to low the 15 seconds, the fan rotates in REMARK In some cases, the screen in Step 1 may switch to the sc reen on the right (red display) w 4, and the fan may not ro ithout switching to the screen in tate in reverse. This is designe Step d to protect the equipment an reverse depending on the temperature. d to prevent the fan from rotating in water temperature and hydraulic oil If it is desired to rotate the f an in reverse, press Back switch (8), switch to the initial screen, then carry out the warming run the engine at low idling or st -up or cooling-down operation.
op it, If the water temperature an d hydraulic temperature on the i nitial screen indicates ranges ( A) - (B) shown in the diagram o n the right, the fan can be rotate d in reverse.Carry out the procedure in order from Step 1. The system is controlled so that when the fan is rotating in reverse, the work equipme nt makes almost no movement even when the levers are oper ated. Rotating the fan in rever se is intended for use in cleanin g the radiator, so when carryin g out operations and moving th e work equipment, switch the fa n to the normal direction of rot ation before starting operations.