HEATING AND AIR CONDITIONING Automatic Control Mode Using the automatic mode: is located at the base of the windshield on the driver’s side of the instrument panel. Do not block this sensor. Your vehicle’s air conditioning system is equipped with an automatic button that provides complete cab climate control without driver interaction. When selected, the system will manipulate the air distribution, air temperature, fan speed, A/C compressor, and cab air recirculation to achieve the comfort level selected on the temperature dial. The button that enables automatic mode is labeled AUTO. The system will remain in automatic mode until the driver adjusts the dials on the control. Step 1:
Turn on HVAC by rotating fan speed control clockwise. Step 2: To engage automatic mode, press the AUTO button. Step 3: To adjust cab temperature, rotate the temperature dial to the desired temperature. The system automatically adjusts to achieve the desired cab temperature. 3 The system will achieve the comfort level associated with the selected temperature on the temperature dial. Therefore, depending on the specific environmental conditions, the air temperature can be slightly higher or lower than the set point. This is a normal function of the AUTO mode and is not to mistaken for a malfunctioning system.
Adjust the temperature knob and the system will respond to obtain the selected comfort level as quickly as possible. 1 Sunlight Sensor Partial Automatic During AUTO mode the operator may override any setting and operate in a partial automatic mode. This can be done via the dials and/or buttons The AUTO function uses a sun light sensor to measure the amount of sunlight entering the cab. This sensor (04/13) Y53-1200-1B1 3-83