HEATING AND AIR CONDITIONING CAUTION Manual Windshield Defrosting/Defogging dial to maintain a clear windshield while providing heat to the floor. This setting may be helpful in conditions where the windshield re-fogs. To increase the effectiveness of the defroster, engage the A/C compressor. During extreme cold weather, do not blow hot defroster air onto cold wind shields. This could crack the glass. Turn the Air Flow Control Dial to Defrost and adjust the fan speed ac cordingly while the engine warms. If the engine is already warm, move the Temperature Control Dial to cool, then gradually increase the temperature when you see that the windshield is starting to warm up.
Failure to comply may result in equipment damage. The manual defrost/defogging mode differs from the MAX defrost mode by allowing the driver to select an air temperature other than full heat. This allows the driver to maintain a constant cab temperature while defrosting the windshield. Note however that performance may be reduced. 3 Step 1: Adjust the fan speed to high by rotating the fan control dial clockwise. Step 2: Set the air distribution dial to the defrost mode setting. This automatically engages the outside air and A/C compressor. Step 3: Adjust the temperature dial to add heat as needed.
For maximum performance, adjust the temperature to maximum heat by rotating the temperature dial clockwise. The driver may also use the floor/defrost setting on the air control (04/13) Y53-1200-1B1 3-87