AIR SYSTEM Air Gauges and Air Leaks If the light and alarm do not turn off at start-up, do not try to drive the vehicle until the problem is found and fixed. If the pressure in either or both systems is too low for normal brake operation, i.e., the pointer of one gauge falls below 65 psi (448 kPa), a warning light on the gauge will glow and the audible alarm will sound. Your vehicle comes with air pressure gauges for two separate systems, Primary and Secondary: the Primary gauge indicates pressure in the rear braking system; the Secondary gauge indicates pressure in the front braking system. Each gauge indicates the amount of air pressure in pounds per square inch (psi).
Secondary Air Pressure Gauge Follow the procedure below to check the compressed air system for leaks: NOTE 1. Periodically, or after maintenance or replacement of air system components: Do not operate the vehicle if leakage in the air system is detected. Con duct the following procedure and con tact an authorized dealer (or any other properly equipped service center) if a leak is detected. Failure to check the brakes or follow these procedures could cause a system failure, increas ing the risk of an accident and may result in death, personal injury, equip ment or property damage. WARNING! Park brakes lock up at 60 psi (414 kPa), the audible alarm will sound at 65 psi (448 kPa). 2.
Build up air pressure in the system to the governor cutout point or until 120 psi (827 kPa) is reached. 5 3. Stop the engine and release the service brakes. Primary Air Pressure Gauge 4. Without applying the brake pedal, observe the rate of air pressure drop. This rate should not exceed 2.0 psi (14 kPa) per minute. (04/13) Y53-1200-1B1 5-55