PACCAR Inc. T680 — Air Compressor

AIR SYSTEM Air Compressor 5. Start the engine and build up the Operation air pressure again. Preventive Maintenance The following service checks are provided for your information only and should be performed by a certified mechanic. Contact your dealer or the engine manufacturer's Maintenance Manual for further information on servicing air compressors. 6. Stop the engine, and apply the All compressors, regardless of make brakes fully. Apply the brake pedal or model, run continuously while the and hold it down for five minutes. engine is running. System pressure The pressure drop should not is controlled by the governor.

The exceed 3.0 psi (21 kPa) per governor acts in conjunction with minute. the unloading mechanism in the compressor cylinder block to start 7. If you detect excessive leakage and stop compression of air. The (air pressure loss greater than 3.0 compressor is unloaded when the psi (21 kPa) after five minutes of system pressure reaches 120 psi (827 brake application), a leakage test kPa) and compression is reestablished should be made at the air line when system pressure falls to 100 psi connections and at all air brake (690 kPa). control units. These tests should determine where air is escaping.

After completing any repairs to the air system, always test for air leaks, and check the brakes for safe operation before putting the vehicle in service. Below is a list of areas to maintain for the air compressor: 5 Inspect compressor air filter element, if so equipped, and replace element if clogged. Check compressor mounting and drive for alignment and belt tension. Adjust if necessary. Remove compressor discharge valve cap nuts and check for 5-56 Y53-1200-1B1 (04/13)