COOLING SYSTEM rate until the surge tank is full (to the base of the fill neck). It may be necessary to pause for 1 minute and then re-fill if the fluid level dropped. 9. Fill the surge tank as necessary to raise the coolant level to Ѕ in. above the level. Engine (Block) Heater WARNING! 10. Operate the engine at high idle for another 10 minutes and then fill the surge tank again to Ѕ" above the level. Do not use the heater if there are any signs of problems. Engine block heaters can cause fires resulting in death, personal injury, equipment or property damage if not properly maintained and operated. Regularly inspect the engine block heater wiring and connector for damaged or frayed wires.
Contact your authorized dealer or the manufacturer of the heater if you are in need of repairs or informa tion. Failure to comply may result in death, personal injury, equipment or property damage. 5. Close any drain valves that were opened in Step 1. 6. Start the engine and idle at low RPM. 11. Replace the surge tank fill cap. 7. During low rpm idle, air will purge from the cooling system which will lower the coolant level in the surge tank. Continue to fill the surge tank until the coolant level remains approximately Ѕ in. above the "MIN" line. This may take up to 2 minutes, depending on the outside temperature. Check the coolant level after each trip. Add coolant as necessary.
You may find your coolant level is not up to the correct level soon after you have filled the radiator. This may be because all of the trapped air in the system has not yet been purged. It takes a little time for all the air to leave the system after you fill your radiator. 5 8. Operate the engine throttle until the operating temperature stabilizes (when the thermostat opens). Always unplug the block heater be fore starting your engine. Damage to the cooling system could occur if not turned OFF (unplugged). CAUTION (04/13) Y53-1200-1B1 5-75