NOISE AND EMISSION CONTROL WARNING! Exhaust Tail Pipe 3. Using a 27 mm socket wrench (DIN3124), remove the filter cap Check the mounting. Tighten as that is screwed to the DEF Supply necessary. The miter cut at the tip pump. of the pipe must be facing the rear of the vehicle. Do not modify the end of the pipe in any way. The exhaust piping can become ex tremely hot during engine operation and can cause personal injury includ ing serious burns to the skin. Allow adequate cooling time before working near any part of the exhaust system. 2. Remove the pump protective plate mounted on the bottom of the DEF tank. 5 5-122 Y53-1200-1B1 (04/13)