PACCAR Inc. T680 — Wheel Mounting and Fastening

TIRES AND WHEEL Threads should be clean and dry. Do not lubricate wheel nuts or studs. Proper Torque and Sequence Proper wheel torque can best be obtained on level ground. Install lug nuts and finger-tighten in the numerical sequence as shown below, see Nut Tightening Sequence for Hub Piloted Disc Wheels on page 5-143 or Nut Tightening Sequence for Stud Piloted Disc Wheels on page 5-144. This procedure will ensure that the wheel is drawn evenly against the hub. Torque each nut to the torque value listed in Wheel Cap Nut Torque on page 5-142. WARNING! Tighten wheel cap nuts properly.

If they are not tightened properly, wheel nuts could eventually cause the wheel to become loose, to fail, and/or to come off while the vehicle is moving, possibly causing loss of control and may result in death, personal injury, equipment or property damage. 5 Nut Tightening Sequence for Hub Piloted Disc Wheels (04/13) Y53-1200-1B1 5-143 WHEEL and NUT CONFIGURATION STUD SIZE TORQUE FOR INNER and OUTER CAP NUTS and RIM CLAMP NUTS Nm Lb-Ft Stud Backnuts (when used) 3/4-16 240-270 175-200 1-14 240-410 175-300 Cast Spoke Wheel Assembly 1/2” Dia. 5/8” Dia. 3/4” Dia. Rim Clamp Nut Torque 110-120 80-90 220-250 160-185 305-335 225-245