POWER PRODUCTION - ENGINE COOLANT SYSTEM Sensing system Coolant temperature - Incorrect value (B.50.A.95.90 - G.30.C.10) AFX8010 E0152-02 - Coolant Temperature Sensor Context: This fault code is sent by the ECU to the CCM2 module via CAN when the ECU detects a fault with the engine coolant temperature sensor B-44 circuit. Cause: ECU coolant temperature sensor B-44 reports an error. Possible failure modes: 1. Sensor failed. 2. Sensor wiring shorted or open. 3. Internal failure in ECU. Solution: 1. Key OFF. Disconnect the engine coolant temperature sensor connector X373 , and install a jumper wire between pins 1 & 2. Carefully remove connector X192 from the ECU module.
Use a multimeter to check for continuity between connector X192 pins 5 & 22. A. If there is continuity, continue with step 2 . B. If there is no continuity, there is an open circuit in one of the two coolant temperature sensor wires. Locate the open and repair. 2. Remove the jumper wire from connector X373 . Use a multimeter to check for continuity between connector X192 pins 5 & 22 and chassis ground. There should not be continuity to ground. A. If there is continuity to ground, there is a short to ground in the Iveco engine harness between connector X192 and connector X373 . Locate the short and repair. B. If there is no continuity to ground on either wire, continue with step 3 . 3.
Use a multimeter to check for continuity between connector X192 pin 5 and all other pins in the connector. There should not be any continuity to any other pins. Repeat this process for connector X192 pin 22. A. If there is a continuity to any other wire, there is a short circuit in the Iveco engine harness between connector X192 and connector X373 . Locate the short and repair. B. If there is no continuity to other wires, the coolant temperature sensor is faulty.Replace the coolant temperature sensor. 9675 1 27/05/2004 B.50.A / 42