POWER PRODUCTION - LUBRICATION SYSTEM Sensing system Oil temperature - Open circuit (B.60.A.95.92 - G.30.B.50) AFX8010 E0153-05 - Engine Oil Temperature Sensor Cause: The engine oil temperature sensor (B-03) circuit is open. Possible failure modes: 1. Sensor supply or ground wiring is open. 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "ENGINE" sort menu, and select "OIL TEMP SEN" to check the voltage range. The proper voltage range is 0.5 - 4.9 volts . A. If the voltage reading is high out of range ( 4.9 - 5.2 volts ), continue with Step 2 . B.
If the voltage reading is within the proper limits, continue the troubleshooting at Step 8 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the engine oil temperature sensor connector X311 . Use a jumper wire to short Connector X311 pin 1 to chassis ground. A. If voltage drops to less than 0.5 volts , the open circuit is not in the supply side of the circuit. Continue with Step 5 . B.
If the voltage remains high, continue with Step 3 . 3. Disconnect the Iveco engine harness from the engine (EN) harness at connector X197 . Use a jumper wire to short the engine harness end of connector X197 pin 9 to ground. A. If voltage drops to less than 0.5 volts , the open is in the Iveco engine harness between connector X197 pin 9 and connector X311 pin 1 on the blue wire. Locate the open and repair. B. If the voltage remains high, continue with Step 4 . 4. Disconnect the engine (EN) harness from the main frame (MF) harness at connector X010 . Use a jumper wire to short the main frame (MF) harness end of connector X010 pin 10 to chassis ground. A.
If voltage drops to less than 0.5 volts , the open is in the engine (EN) harness between connector X010 pin 10 and connector X197 pin 9 wire 504 yellow. Locate the open and repair. B. If voltage remains high, the open is in the main frame (MF) harness between connector X010 pin 10 and connector X016 pin J2-27 wire 504 yellow. Locate the open and repair. 5. Disconnect the engine oil temperature sensor connector X311 . Use a multimeter to check for continuity between the harness end of connector X311 pin 2 and chassis ground. A. If there is continuity, the ground path for the sensor is complete, and the fault is in the sensor itself. Replace the sensor. B.
If there is no continuity to ground, the ground path for the sensor is open. Continue with Step 6 . 6. Disconnect the Iveco engine harness from the engine (EN) harness at connector X197 . Use a multimeter to check for continuity between the engine (EN) harness end of connector X197 pin 10 and chassis ground. 9676 1 27/05/2004 B.60.A / 19