Case IH AFX8010 — LUBRICATION SYSTEM

POWER PRODUCTION - LUBRICATION SYSTEM Sensing system Oil pressure - Open circuit (B.60.A.95.91 - G.30.B.50) AFX8010 E0161-05 - Oil Pressure Sensor Cause: The engine oil pressure sensor (B52) circuit signal wire is open or shorted to ground. Possible failure modes: 1. Sensor signal wiring open or shorted to ground. 2. Loss of power to the sensor. 3. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "ENGINE" sort menu, and select "OIL PRESS SEN" to check the voltage range. The proper voltage range for the engine oil pressure sensor (key On, engine OFF) is 0.5 - 0.8 volts .

The proper voltage range for the engine oil pressure sensor (key On, engine Running) is 0.8 - 4.9 volts . A. If the voltage reading is low out of range ( 0.3 volts ), continue with Step 2 . B. If the voltage is normal, the shorted wire may not be open or grounded at this time. Continue with Step 12 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the engine oil pressure sensor connector X337 .

Use a multimeter to check for voltage on connector X337 pin B. There should be 5 volts present. A. If no voltage is found, continue with Step 3 . B. If correct voltage is found, continue with Step 6 . 3. Disconnect the Iveco engine harness from the engine (EN) harness at connector X197 . Use a multimeter to check for voltage on connector X197 pin 5. There should be 5 volts present. A. If no voltage is found, continue with Step 4 . B. If correct voltage is found, there is an open circuit in the Iveco engine harness between connector X197 pin 5 and connector X337 pin B on the orange wire. Locate the open and repair. 4.

Disconnect the engine (EN) harness from the main frame (MF) harness at connector X010 . Use a multimeter to check for voltage on connector X010 pin 13. There should be 5 volts present. A. If voltage is found, there is an open circuit in the engine (EN) harness between connector X197 pin 5 and connector X010 pin 13 wire 490 pink or 463 pink. Locate the open and repair. B. If no voltage is found, continue with Step 5 . 5. Carefully disconnect the main frame harness from the CCM2 module at connector X016 . Use a multimeter to check for voltage on the CCM2 module connector X016 pin J2-31. There should be 5 volts present. A.

If voltage is found, there is an open circuit in the main frame (MF) harness between connector X010 pin 13 and connector X016 pin J2-31 wire 459 pink or 463 pink. Locate the open and repair. B. If no voltage is found, there is an internal fault with the CCM2 module. Replace the module. 9676 1 27/05/2004 B.60.A / 30