POWER PRODUCTION - LUBRICATION SYSTEM 6. Disconnect the engine oil pressure sensor connector X337 . Use a multimeter to check for continuity between connector X337 pin C and chassis ground. A. If continuity is found, continue with Step 7 . B. If no continuity is found, continue with Step 9 . 7. Disconnect the Iveco engine harness from the engine (EN) harness at connector X197 . Use a multimeter to check for continuity between the engine (EN) harness end of connector X197 pin 6 and chassis ground. A. If there is continuity, continue with Step 8 . B.
If there is no continuity, there is a short to ground in the Iveco engine harness between connector X197 pin 6 and connector X337 pin C on the orange wire. Locate the short and repair. 8. Disconnect the engine (EN) harness from the main frame (MF) harness at connector X010 . Use a multimeter to check for continuity between the harness end of connector X010 pin 6 and chassis ground. A. If there is no continuity, there is a short to ground in the engine (EN) harness between connector X010 pin 6 and connector X197 pin 6 wire 419 yellow. Locate the short and repair. B.
If there is continuity to ground, there is a short to ground in the main frame (MF) harness between connector X010 pin 6 and connector X016 pin J2-33 wire 419 yellow. Locate the short and repair. 9. Carefully disconnect the main frame harness from the CCM2 module at connector X016 . Install a jumper wire between the harness end of connector X016 pin J2-33 and chassis ground. Use a multimeter to check for continuity between connector X337 pin C and chassis ground. A. If continuity is found, continue with Step 12 . B. If no continuity is found, continue with Step 10 . 10. Disconnect the Iveco engine harness from the engine (EN) harness at connector X197 .
Use a multimeter to check for continuity between the engine (EN) harness end of connector X197 pin 6 and chassis ground. A. If there is no continuity, continue with Step 11 . B. If there is continuity, there is an open circuit in the Iveco engine harness between connector X197 pin 6 and connector X337 pin C on the orange wire. Locate the open and repair. 11. Disconnect the engine (EN) harness from the main frame (MF) harness at connector X010 . Use a multimeter to check for continuity between the main frame (MF) harness end of connector X010 pin 6 and chassis ground. A.
If there is continuity, there is an open circuit in the engine (EN) harness between connector X010 pin 6 and connector X197 pin 6 wire 419 yellow. Locate the open and repair. B. If there is no continuity to ground, there is an open circuit in the main frame (MF) harness between connector X010 pin 6 and connector X016 pin J2-33 wire 419 yellow. Locate the open and repair. 12. Operate the machine while monitoring Universal Display Plus "DIAG" screen.. A. If no high out of range readings are indicated, erase the fault code and continue operation. 9676 1 27/05/2004 B.60.A / 31