POWER PRODUCTION - STARTING SYSTEM STARTING SYSTEM - Dynamic description (B.80.A - C.30.A.10) AFX8010 24V STARTING SYSTEM CIRCUIT OPERATION Wiring harness - Electrical schematic frame 01 (A.30.A.88 - C.20.E.01) Wiring harness - Electrical schematic frame 09 (A.30.A.88 - C.20.E.09) Wiring harness - Electrical schematic frame 17 (A.30.A.88 - C.20.E.17) Wiring harness - Electrical schematic frame 29 (A.30.A.88 - C.20.E.29) The Battery Switch S-52 (if equipped) must be closed before attempting to start the vehicle.
When the Key Switch S-02 (frame 29) is turned to the RUN position and the Neutral Switch S-22 (frame 09) is closed (propulsion handle in neutral), current flows through Fuse F-48 (frame 17) and the Neutral Switch to energize the coil of the Neutral Start Relay K-23 (frame 01). When the Key Switch is turned to the START position, current flows from Fuse F-38 through the key switch and Neutral Start Relay K-23 to the coil side of the Start Relay K-36. The Start relay K-36 coil circuit is grounded to the engine ground #5, so the relay will energize.
This closes the switch side of the Start Relay and allows current flow to energize the solenoid of the 24V Start Relay K-38, as well as energizing the starter solenoid on the 24V starter motor M-29. The 24V starting circuit starts with the rear 12V battery G-03 obtaining ground through the 24V Battery Switch S-52 (EU only, all other markets are grounded directly to engine ground #5) and supplying 12V to terminal 30 of the 24V Start Relay. This terminal supplies 12V through the now closed 24V Start Relay to the negative side of the front 12V battery G-02. This places two batteries in series creating 24 volts at the B+ terminal of the 24V Starter motor M-29. NOTE:
The cab 12V power supply is connected to terminal 30 of the 24V start relay K-38, so that the cab fuse panel will only ever receive 12V, even when the 24V starter system is engaged. 9677 1 27/05/2004 B.80.A / 5