POWER PRODUCTION - STARTING SYSTEM Cold start aid Pre-heating - Dynamic description (B.80.A.30.81 - C.30.A.10) AFX8010 Grid Heater Operation Wiring harness - Electrical schematic frame 02 (A.30.A.88 - C.20.E.02) Wiring harness - Electrical schematic frame 03 (A.30.A.88 - C.20.E.03) The grid heater relay K39 receives power from fuse F01 through an energized ECU Power relay K14, which also provides power to the ECU. The ECU activates the grid heater relay K39 by completing the ground path for the relay, and sends a CAN message to CCM2 whenever this occurs. The CCM2 module then turns on the cold start indicator light E36 in the cab.
When the key switch is first turned on and the ECU powers up, it reads the temperatures from the fuel temperature sensor B36, coolant temperature sensor B44 and air temperature sensor B54. If the one or more of these temperatures are less than 10 degrees C (50 degrees F), and the battery voltage is greater than 7 volts, the ECU will activate the grid. In "Stand-by" mode, the grid heater will remain engaged for an additional 15 seconds, and then shut off. The grid heater will be reengaged when the operator starts cranking the engine, and will remain on for a certain period of time after the engine starts.
The amount of time the grid heater remains on after the engine is running is dependant on the specific temperatures read from the fuel temperature sensor B36, coolant temperature sensor B44 and air temperature sensor B54, and may vary between 80 and 300 seconds. 9677 1 27/05/2004 B.80.A / 6