Case IH AFX8010 — TRANSMISSION Mechanical

POWER TRAIN - TRANSMISSION Mechanical 4. Install the castle head lock nut and torque to 25 Nm (18 lb ft) and then torque further until the nut can be assembled. Use a new cotter pin. NOTE: If the input shaft, the drive shaft and the differential are not assembled into the gearbox, bring the shifting disc in it’s highest position by turning the shifting disc housing out until the shifting disc blocks against the gearbox housing. 3349a 4 5. Install micro-switch bar (2) , install five washers and bolts and tighten five bolts (1) . Torque the bolts to 4 - 6 Nm (3 - 4 lb ft) . 3330a 5 6. Install indicator plate (2) and tighten nut (1) to a torque of 8 - 12 Nm (71 - 106 lb in) . 3329a 6 7.

Apply Loctite 573 following around the mating surface and around the bolt holes. Spread evenly and wipe off the excess. 3351a 7 9680 1 27/05/2004 C.20.B / 38