POWER TRAIN - TRANSMISSION Mechanical 8. Install retaining ring (1) . 3410a 8 9. Install the two springs and two balls (3) and at the same time install selector ring (2) . Do not to lose the balls. Install needle bearings (1) . 10. Install gear (1) . Install washer (2) . 3408a 9 3413a 10 11. Heat bearing (4) to 80 °C ( 176 °F ) and install it on the input shaft. Install washer (3) . Install new lock-washer (2) . Install nut (1) using tool 380001074 and tighten to a torque of 150 - 170 Nm ( 111 - 125 lb ft ). Secure nut (1) by bending a lip of the lock-washer in one of the notches of the nut. 3406a 11 9680 1 27/05/2004 C.20.B / 55