DISTRIBUTION SYSTEMS - SECONDARY HYDRAULIC POWER SYSTEM 6. Disconnect the gearbox (GB) harness from the main frame (MF) harness at connector X011 . Use a multimeter to check for continuity between the harness end of connector X011 pin 31 and chassis ground. A. If there is no continuity, there is a short to ground in the gearbox (GB) harness between connector X011 pin 31 and connector X098 pin C wire 423 yellow. Locate the short and repair. B. If there is continuity to ground, there is a short to ground in the main frame (MF) harness between connector X011 pin 31 and connector X016 pin J2-19 wire 423 yellow. Locate the short and repair. 7.
Carefully disconnect the main frame (MF) harness from the CCM2 module at connector X016 . Install a jumper wire between the harness end of connector X016 pin J2-19 and chassis ground. Use a multimeter to check for continuity between connector X098 pin C and chassis ground. A. If continuity is found, continue with Step 9 . B. If no continuity is found, continue with Step 8 . 8. Disconnect the gearbox (GB) harness from the main frame (MF) harness at connector X011 . Use a multimeter to check for continuity between the harness end of connector X011 pin 31 and chassis ground. A.
If there is continuity, there is an open circuit in the gearbox (GB) harness between connector X011 pin 31 and connector X098 pin C wire 423 yellow. Locate the open and repair. B. If there is no continuity to ground, there is an open circuit in the main frame (MF) harness between connector X011 pin 31 and connector X016 pin J2-19 wire 423 yellow. Locate the open and repair. 9. Operate the machine while monitoring Universal Display Plus "DIAG" screen. A. If no high out of range readings are indicated, erase the fault code and continue operation. 9666 1 27/05/2004 A.12.A / 13