POWER TRAIN - TRANSMISSION Mechanical Sensing system Ground speed sensor - Open circuit (C.20.B.95.80 - G.30.B.50) AFX8010 E0142-05 - Ground Speed Sensor Cause: The ground speed RPM sensor B-17 circuit is open. Possible failure modes: 1. Sensor supply or ground wiring is open. 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "GROUND DRIVE" sort menu, and select "GROUND SPD SEN" to check the voltage range. The proper voltage for the sensor when blocked by ferrous metal is 5.6 - 7.3 volts . The proper voltage for the sensor when not blocked by ferrous metal is 0.5 - 5.6 volts . A.
If the voltage reading is 7.3 - 9.0 volts , continue with step 2 . B. If the voltage reading is within the proper limits, continue the troubleshooting at step 6 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector is fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the ground speed RPM sensor connector X087 at the transmission. Use a jumper wire to short connector X087 pin B to chassis ground. A.
If the voltage drops to 0 - 0.5 volts indicating a short to ground, the open circuit is not in the supply side of the circuit. Continue with step 4 . B. If the voltage remains at 7.3 - 9.0 volts , continue with step 3 . 3. Disconnect the lower frame (LF) harness from the front frame (FF) harness at connector X023 . Use a jumper wire to short connector X023 pin 6 to chassis ground. A. If the voltage drops to 0 - 0.5 volts indicating a short to ground, there is an open circuit in the lower frame (LF) harness between connector X023 pin 6 and connector X087 pin B wire 403 yellow. Locate the open and repair. B.
If the voltage remains at 7.3 - 9.0 volts , there is an open circuit in the front frame (FF) harness between connector X023 pin 6 and connector X017 pin J3-14 wire 403 yellow. Locate the open and repair. 4. Disconnect the ground speed RPM sensor connector X087 at the transmission. Use a multimeter to check for continuity between the harness end of connector X087 pin A to chassis ground. There should be continuity to ground. A. If there is continuity to ground, the ground path for the sensor is complete, and the fault is in the sensor itself. Replace the sensor. B. If there is no continuity to ground, the ground path for the sensor is open. Continue with step 5 . 5.
Disconnect the lower frame (LF) harness from the front frame (FF) harness at connector X023 . Use a multimeter to check for continuity between the front frame (FF) harness end of connector X023 pin 5 to chassis ground. There should be continuity to ground. A. If there is continuity to ground, there is an open circuit in the lower frame (LF) harness between connector X023 pin 5 and connector X087 pin A wire 717 blue or wire 042 blue. Locate the open and repair. 9680 1 27/05/2004 C.20.B / 174