Case IH AFX8010 — TRANSMISSION Mechanical

POWER TRAIN - TRANSMISSION Mechanical B. If there is no continuity to ground, there is an open circuit in the front frame (FF) harness between connector X023 pin 5 and connector X017 pin J3-18 wire 042 blue or wire 766 blue. Locate the open and repair. 6. Turn the key to the "ON" position. Remove the ground speed RPM sensor B-17 from the transmission top cover. Observing the LED on the sensor, place ferrous metal in front of the sensor, and then remove. A. If the LED does not change state (turn on and off), the sensor is not functioning. Replace the sensor and continue the troubleshooting at step 1 . B. If the LED changes state (turns on and off), the sensor is functioning properly.

Clear the fault code and continue operation. Sensing system Ground speed sensor - Overview (C.20.B.95.80 - C.10.A.10) 40034843A5 1 The ground speed sensor B-17 (1) is located on the top cover of the transmission, positioned above the differential ring gear. The sensor is connected ( X087 ) to the lower frame (LF) harness at (2) , and provides an input to the CCM2 module at connector X017 pin J3-14. The ground speed sensor B-17 circuit is also monitored by the CCM2 module; in the event that a fault occurs with the sensor itself or the wiring to the sensor, a fault code will be displayed to the operator.

E0142-03 - Ground Speed Sensor E0142-04 - Ground Speed Sensor E0142-05 - Ground Speed Sensor The input from the ground speed sensor B-17 supports several functions, such as: ground speed readout on display. prevents activation of the transmission shift motor M-02 when the value from the sensor is above the threshold value. This avoids gear shifting when the gearbox has components that are in motion. automatic reel speed synchronization with ground speed. automatic feeder speed synchronization with ground speed. 9680 1 27/05/2004 C.20.B / 175