Case IH AFX8010 — TRANSMISSION Hydrostatic

POWER TRAIN - TRANSMISSION Hydrostatic TRANSMISSION Hydrostatic - Filling (C.20.F - F.60.A.10) AFX8010 NOTE: Before installing a new motor or a new pump, shipment oil should be drained from the new pump or motor case. 1. Place wheel chocks in front and behind the front wheels to prevent movement of the combine. For machines not equipped with powered rear axles, also put blocks in front and behind the rear wheels. For machines equipped with a powered rear axle, the rear axle must be jacked up and placed on suitable jack stands to raise the rear tires from the ground. Turn the powered rear axle off using the switch in the cab.

WARNING M947 - Make sure the powered rear axle is securely suspended off the ground and turned off to prevent unexpected movement of the machine. 2. Remove the transmission drive shaft couplings (1) on both sides of the transmission. Make sure the couplings are secured to the drive shafts. CAUTION M948 - Before disconnecting the drive shafts, secure the machine in place by using adequate wheel chocks against the front and rear of both traction and steering wheels. IMPORTANT: Only use Case IH AKCELA hydraulic oil. IMPORTANT: Oil quality and cleanliness is of utmost importance for the reliability and life of the hydraulic and hydrostatic system.

Deviation from the prescribed oil specification may lead to severe damage and void warranty. BSC1308B 1 3. Remove fitting (1) from the control pressure manifold (2) . 10033614A5 2 9681 1 27/05/2004 C.20.F / 13