POWER TRAIN - TRANSMISSION Hydrostatic 4. Loosen hose (1) from the outlet side of the inner pump #1 on the triple gear pump. Add oil at (1) fig. 2 until oil seeps from the hose. Reconnect both fittings. 10033615A5 3 5. Loosen the temperature sensor (1) at the ground drive motor to allow air to escape from the oil lines during filling. Do not remove the sensor. 10033617A5 4 6. Disconnect the fitting (1) from the drain return manifold. Loosen the fitting (2) at the elbow enough to rotate the tube upward for filling. Fill the tube until oil seeps from the temperature sensor located at the ground drive motor. 7. Tighten the temperature sensor to stop oil flow. 50035349A5 5 8.
Fill the tube with as much oil as possible. Connect the fitting to the drain return manifold. Tighten the elbow coupler. 9681 1 27/05/2004 C.20.F / 14