Case IH AFX8010 — TRANSMISSION Hydrostatic

POWER TRAIN - TRANSMISSION Hydrostatic 6. Disconnect connector X008 . Use a multimeter to check for continuity between the front frame (FF) harness end of connector X008 pin 12 and chassis ground. There should not be continuity to ground. A. If there is no continuity to ground, there is a short to ground in the main frame (MF) harness between connector X011 and connector X008 wire 880 white. Locate the short and repair. B. If there is continuity to ground, there is a short to ground in the front frame (FF) harness between connector X008 and connector X017 pin J3-31 wire 880 white. Locate the short and repair. 7.

Use a multimeter to check for continuity between the harness end of connector X100 pin A and chassis ground. There should not be continuity to ground. A. If there is continuity to ground, continue with step 8 . B. If there is no continuity to ground, continue with step 10 . 8. Disconnect connector X011 . Use a multimeter to check for continuity between the main frame (MF) harness end of connector X011 pin 15 and chassis ground. There should not be continuity to ground. A. If there is no continuity to ground, there is a short to ground in the gearbox (GB) harness between connector X011 and connector X100 wire 879 grey.Locate the short and repair. B.

If there is continuity to ground, continue with step 9 . 9. Disconnect connector X008 . Use a multimeter to check for continuity between the front frame (FF) harness end of connector X008 pin 11 and chassis ground. There should not be continuity to ground. A. If there is no continuity to ground, there is a short to ground in the main frame (MF) harness between connector X011 and connector X008 wire 879 grey. Locate the short and repair. B. If there is continuity to ground, there is a short to ground in the front frame (FF) harness between connector X008 and connector X017 pin J3-21 wire 879 grey. Locate the short and repair. 10.

Visually inspect the harness and connectors for damage, bent or dislocated, corroded terminals, or broken wires. A. If no damage is found, erase the fault code and continue operation. 9681 1 27/05/2004 C.20.F / 29