TRAVELLING - FRONT AXLE 13. Apply a light coating of grease on O-ring (1) and install O-ring (1) in ring gear (2) . zda43622a 12 14. Install inner final drive housing (1) onto ring gear. zda46382a 13 15. Apply thread locking compound type 1 (Loctite 242) to bolts (1) . Screw in twelve bolts (1) and lock washers. Torque to 320 Nm ( 236 lb ft ). zda46392a 14 16. Install bearing (1) . Apply a load of 150 kg ( 330 lb ) on the bearing cone back face (1) and turn final drive around the output shaft to correctly seat the bearing cone. Measure distance X between the cone back face of bearing (1) and the upper flat surface of the output shaft. IMPORTANT:
Be sure the 12 bolts (1) are tightened to specified torque before measuring distance X. Measure distance X with the load applied on the bearing cone back face. NOTE: The required shim pack can be defined as follows: Shim pack = X - 0.35 mm (X - 0.014"). zda4163b 15 9686 1 27/05/2004 D.10.A / 28