Case IH AFX8010 — PARKING BRAKE Hydraulic

TRAVELLING - PARKING BRAKE Hydraulic Sensing system Pressure sensor - Open circuit (D.32.C.95.81 - G.30.B.50) AFX8010 E0155-05 - Park Brake Pressure Sensor Cause: The park brake pressure sensor (B-53) circuit signal wire is open or shorted to ground. Possible failure modes: 1. Sensor signal wiring open or shorted to ground. 2. Loss of power to the sensor. 3. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "BRAKES" sort menu, and select "PARK PRESS SEN" to check the voltage range. The proper voltage range for the park brake pressure sensor (key ON, engine OFF) is 0.5 - 0.8 volts .

The proper voltage range for the park brake pressure sensor (key ON, engine Running, park brake OFF) is 0.8 - 4.9 volts . A. If the voltage reading is low out of range ( 0.3 volts ), continue with Step 2 . B. If the voltage is normal, the shorted wire may not be open or grounded at this time. Continue with Step 8 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the park brake pressure sensor connector X368 .

Use a multimeter to check for voltage on connector X368 pin B. There should be 5 volts present. A. If no voltage is found, continue with Step 3 . 3. Carefully disconnect the main frame harness from the CCM2 module at connector X016 . Use a multimeter to check for voltage on the CCM2 module connector X016 pin J2-31. There should be 5 volts present. B. If correct voltage is found, continue with Step 4 . A. If voltage is found, there is an open circuit in the main frame (MF) harness between connector X368 pin B and connector X016 pin J2-31 wire 459 pink or 1199 pink. Locate the open and repair. B. If no voltage is found, there is an internal fault with the CCM2 module. Replace the module. 4.

Disconnect the park brake pressure sensor connector X368 . Use a multimeter to check for continuity between connector X368 pin C and chassis ground. A. If continuity is found, continue with Step 5 . B. If no continuity is found, continue with Step 6 . 5. Disconnect the main frame (MF) harness from the front frame (FF) harness at connector X008 . Use a multimeter to check for continuity between the harness end of connector X008 pin 7 and chassis ground. A. If there is no continuity, there is a short to ground in the main frame (MF) harness between connector X008 pin 7 and connector X368 pin C wire 1197 yellow. Locate the short and repair. B.

If there is continuity to ground, there is a short to ground in the front frame (FF) harness between connector X008 pin 7 and connector X017 pin J3-34 wire 1197 yellow. Locate the short and repair. 9691 1 27/05/2004 D.32.C / 32