Case IH AFX8010 — PARKING BRAKE Hydraulic

TRAVELLING - PARKING BRAKE Hydraulic 6. Carefully disconnect the main frame harness from the CCM2 module at connector X017 . Install a jumper wire between the harness end of connector X017 pin J3-34 and chassis ground. Use a multimeter to check for continuity between connector X368 pin C and chassis ground. A. If continuity is found, continue with Step 8 . 7. Disconnect the main frame (MF) harness from the front frame (FF) harness at connector X008 . Use a multimeter to check for continuity between the front frame (MF) harness end of connector X008 pin 7 and chassis ground. B. If no continuity is found, continue with Step 7 . A.

If there is continuity, there is an open circuit in the main frame (MF) harness between connector X008 pin 7 and connector X368 pin C wire 1197 yellow. Locate the open and repair. B. If there is no continuity to ground, there is an open circuit in the front frame (FF) harness between connector X008 pin 7 and connector X017 pin J3-34 wire 1197 yellow. Locate the open and repair. 8. Operate the machine while monitoring Universal Display Plus "DIAG" screen.. A. If no high out of range readings are indicated, erase the fault code and continue operation. 9691 1 27/05/2004 D.32.C / 33