BODY AND STRUCTURE - SHIELD Side shield - Install (E.20.A.70 - F.10.A.15) AFX8010 1. To install left-hand lower shielding & service platform, proceed as follows: Move shield assembly into position with a suitable lifting device and insert M10X30 cap screws (1) with lock washers on both sides, and lock nuts. Leave loose until all other attaching points are connected. 40033220A5 1 2. Install two M10X70 cap screws (1) with lock washers under the head and curved washers and lock nuts against the pipe. With weight of assembly supported, tighten. 3.
Install two M10X35 cap screws with lock washers under the heads to the frame bracket at the rear of the drive axle and the front end of the platform support pipe. Assemble lock washers and lock nuts (1) . 40033219A5 2 40033218A5 3 4. Attach rear end of platform to support bracket with M10X60 cap screws with lock washers under head and curved washers and lock nuts (1) against the pipe. Attach tabs of solid shield to support pipe with M8X50 cap screws, lock washers on both ends, and nuts (2) . 40033217A5 4 9696 1 27/05/2004 E.20.A / 5