BODY AND STRUCTURE - SHIELD 5. Tighten bolts (1) while making sure the combine side door panels latch properly. 40033220A5 5 6. Install two service shields (1) and (2) by first coating the upper and lower pivot pins with CASE AKCELA PREMIUM GREASE EP-2 . Then set the shields down on the lower pivots and insert the pins of plate (3) down into the top of the shield pivot tubes. Fasten the plate to the shield support pipe flange with two M8X25 cap screws (4) with lock washers at both ends, and nuts. Wipe off excess lube to avoid attracting dirt. 40033215A5 6 7. Install toolbox on bracket, engaging lip on box with top of bracket.
Then push the bottom of the box inward until tab (1) on bracket fully enters the box. Lock in place by lowering key (2) fully into tab. Replace tray (3) . 40033216A5 7 9696 1 27/05/2004 E.20.A / 6